Garage Door Opens Part Way And Stops

If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.

Garage door opens part way and stops.

It goes partway down reverses direction and goes back up again. This board electrically controls your garage door and will fail if it shorts out. If the door reverses part way down and you are sure there is no obstruction or binding increase the closing force a small amount and try it again. If your garage door opens and suddenly stops it might be because of your logic board.

You push the button to close the garage door. If this setting is improper it can cause your door to stop midway thinking its job is done. Some older garage door openers do not have nicely labeled adjustment screws for force and travel limits. On the other hand if your opener is fairly new you may want to call a professional.

Doing this can save you some amount of cash. Depending on how old your garage door opener is you may want to replace it if it s old. This is almost always the result of a dirty or obstructed safety feature. You might need to consider replacing it if your door is not working properly or you may purchase a new opener.

A faulty logic board could also be a reason your garage door opens then stops. In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor. Unless you want to climb up on a ladder numerous times ask someone to. This indicates that the springs torsion springs in the case of the photo above are working properly and are not the issue.

Your automatic garage door comes with a limit setting that limits the amount of force it is allowed to exert in either opening or closing. The logic board receives and responds signals to any remote. If the door is working properly it should be easy to lift by hand.