Whether you replace or repair put a surge protector on the unit 900 joules or higher and this won t happen again.
Garage door opener wont will reset but not open door.
Check the door s electric eye.
More than likely the logic board took a power surge and needs to be replaced and possibly the wall button or sensors too.
Contact us for garage door spring repair.
Try using your remote to open or close your door to determine if the reprogramming was successful.
Use a screwdriver to tighten the wire.
Open and close door manually.
Its power source is disrupted.
The torsion springs are broken.
If your garage door opener has a button that opens the garage door and another button to close.
Door may be out of balance or springs are broken.
Press the garage door opener button.
A properly balanced door will hold itself halfway open while being supported entirely by its springs.
Opener strains or maxi mum force is needed to operate door.
The limit setting is off.
Your garage door has set limit switches that instruct the motor when to stop running both when it is opening and when it is closing.
Press and hold the wall console button until the garage door is completey closed.
Check for interference from adjacent photo eye sensors of any brand.
11 reasons why your automatic garage door won t open or shut the photo eye is blocked.
Turn the power back on and the door should open and close normally.
Shut off the power to the garage door opener.
Snapped or loose cables.
If the garage door is not opening but the motor is running the problem might rest on the springs in your garage door assembly.
Broken springs are the most common issue at hand whenever a service person is called to a residence to repair a garage door.
The close limit switch may need adjusting.
If an operational problem exists and the garage door opener will not close the opener can be forced to close.
You can try unplugging the unit for 15 minutes but an opener does not have a true reset button.
Check garage door for binding.
To reprogram your garage door remote locate then press your opener s learn button.
The door must be in the closed position to reconnect the opener.
This can happen if a track is accidentally struck by a heavy object and bent outward.
The door has dislodged from its track.
If the garage door opens correctly but fails to close completely there may be one of three common causes.
When a roller on the garage door comes off one of the side tracks the opener won t be able to lift the door.
